Product Description How to use? 1. Clean the dent with a clean wet cloth; 2. Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes; 3. Glue a Tab with hot melt glue: – Use Lifter or T-shaped repairer : Glue a Pulling Tab with hot melt glue on it’s back by glue gun tool; – Use Bridge Puller: Glue the middle tab of Bridge Puller set with hot melt glue on it‘s back by glue gun tool; 4. Put the Tab with hot melt glue at the center of dent fast, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter). 5. Pull out tabs: – Use Lifter: Screw the rotary axis of the Lifter to find a perfect range for the spring which can pull the tab out. Then press the handle to pull out the tabs directly; – Use Bridge Puller: Adjust the three screws’ height to find a perfect place for the Bridge Puller, then pull out the tabs directly; – Use Slide Hammer repairer: Align the T-shaped repairer and press the drawing tabs with hot melt glue, pull the sliding rod backwards to pull up the dent; 6. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen; 7. Use the plastic shovel to remove the glue stuck on the machine body. And then clean the repaired place with a clean wet cloth. We recommend having rubbing alcohol on hand as well to use to remove the glue that sticks to the vehichle. Package content: 1pc Tool bag 21pc Paintless Dent Removal Rods (5A+10B+6C) 1pc LED Line Board 1pc Dent Lifter 1pc 100W Glue Gun 1pc Metal Tap down with 9 heads 10pcs Pro Glue Sticks 28pcs Pro Tabs 1pc Rubber Hammer 1pc Tap Down Hammer 1pc Slider Hammer Lifter 1pc Bridge Puller with 7 Pulling Tabs 1pc T-bar 1pc Bottle